2022 Toyota Sienna Owners Manual - Opening, closing the windows and moon roof

Opening, closing the windows and moon roof

Power windows

Opening and closing procedures

The power windows can be opened and closed using the switches.

Operating the switch moves the windows as follows:

1. Closing
2. One-touch closing*
3. Opening
4. One-touch opening*

*: To stop the window partway, operate the switch in the opposite direction.

Window lock switch

Press the switch down to lock the passenger window switches.

Use this switch to prevent children from accidentally opening or closing a passenger window.

The power windows can be operated when

The engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system).

Operating the power windows after turning the engine off

• Vehicles without a smart key system The power windows can be operated for approximately 45 seconds even after the engine switch is turned to the “ACC” or “LOCK” position. They cannot, however, be operated once either front door is opened.
• Vehicles with a smart key system The power windows can be operated for approximately 45 seconds even after the engine switch is turned to ACCESSORY mode or turned off. They cannot, however, be operated once either front door is opened.

Jam protection function If an object becomes caught between the window and the window frame, window travel is stopped and the window is opened slightly.

When the power window does not close normally

If the jam protection function is operating abnormally and a window cannot be closed, perform the following operations using the power window switch on the relevant door.

• After stopping the vehicle, the window can be closed by holding the power window switch in the one-touch closing position while the engine switch is turned to the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system).
• If the window still cannot be closed even by carrying out the operation explained above, initialize the function by performing the following procedure.

1. Hold the power window switch in the one-touch closing position. Continue holding the switch for 4 seconds or more after the window has closed.
2. Hold the power window switch in the one-touch opening position. Continue holding the switch for 1 second or more after the window has opened completely.
3. Hold the power window switch in the one-touch closing position once again. Continue holding the switch for 1 second or more after the window has closed.

If you release the switch while the window is moving, start again from the beginning. If the window continues to close but then re-open slightly even after performing the above procedure correctly, have the vehicle inspected by your Toyota dealer.

Quarter windows

The quarter windows can be opened to bring in fresh outside air for additional ventilation.

Opening and closing procedures

• Manual type

Pull the handle and swing the window fully out to open.

• Power type

1. Opening
2. Closing

Both the left and right quarter windows move.

The windows can be operated when (power type)

The engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system).

Operating the windows after turning the engine off (power type)

• Vehicles without a smart key system The power type windows can be operated for approximately 45 seconds even after the engine switch is turned to the “ACC” or “LOCK” position. They cannot, however, be operated once either front door is opened.
• Vehicles with a smart key system The power type windows can be operated for approximately 45 seconds even after the engine switch is turned to ACCESSORY mode or turned off. They cannot, however, be operated once either front door is opened

Moon roof

Use the overhead switches to open and close the moon roof.

Opening and closing

Front moon roof

• Vehicles without a rear moon roof

• Vehicles with a rear moon roof

1. Opens the moon roof* The moon roof will stop at the tilt up position once.

   To tilt down, press the opposite side of the switch.

   Press the switch again to open.

2. Closes the moon roof*

*: Lightly press either of the roof switches to stop the moon roof partway.

Rear moon roof (if equipped)

1. Opens the moon roof* The moon roof stops just before it is opened fully. Press the switch again to open fully.
2. Closes the moon roof*

*: Lightly press either of the roof switches to stop the moon roof partway.

Canceling the rear moon roof operation (vehicles with the rear moon roof)

Press the switch to disable the rear moon roof operation from the rear seat.

Pressing the switch again will enable the operation again.

The moon roof can be operated when

The engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system).

Operating the moon roof after turning the engine off

• Vehicles without a smart key system The moon roof can be operated for approximately 45 seconds after the engine switch is turned to the “ACC” or “LOCK” position. It cannot, however, be operated once either front door is opened.
• Vehicles with a smart key system The moon roof can be operated for approximately 45 seconds after the engine switch is turned to ACCESSORY mode or turned off. It cannot, however, be operated once either front door is opened.

Jam protection function

If an object is detected between the moon roof and the frame while the moon roof is closing, travel is stopped and the moon roof opens slightly.

Sunshade

The sunshade can be opened and closed manually. However, both front and rear sunshades open automatically when the moon roof is opened.

When the moon roof does not close normally

1. Stop the vehicle.
2. Press and hold the close switch.* The moon roof will start moving after pausing for about 10 seconds. Continue to hold the switch.
3. Release the button when the moon roof stops moving.

   Within 4 seconds, press and hold the close switch again. Continue to hold the switch as the moon roof opens and closes.

4. Release the close switch when the moon roof completely stops.

*: If the switch is released at the incorrect time, the procedure will have to be performed again from the beginning.